RAIN BIRD MANUAL Pdf Download (2024)

FAQs

How do I know if my rain bird solenoid is bad? ›

terminal (C) on the base module. Then connect the remaining wire from each valve to the field common wire, as shown. D To perform a Valve Test, connect the common wire to the. “COM” terminal and the power wire to the “VT” terminal. This will immediately turn the valve “ON” .

Most automatic sprinkler systems require between 40 to 60 PSI to operate properly. Because water pressure fluctuates throughout the day, it's best to make sure other faucets in your house are off and that you record your water pressure at around the time you will likely be using your irrigation system.

Or, “If the valve works when turned on manually, the problem is most likely with the wiring from the controller to the valve, the wiring at the valve, or the solenoid. Check for any loose or damaged wires and reconnect, repair, or replace them.”

One of the first and most common symptoms is simply no response from the starter when you turn the key – no noises or engine cranking at all. Sometimes, repeatedly trying the ignition can produce a result, but that's not guaranteed. It usually means there's a faulty connection in the solenoid.

High-quality valves tend to last longer than their lower-quality counterparts. When installing an irrigation system, investing in durable valves can significantly extend their lifespan. Quality valves can last 10 to 20 years or more.

There are a few common problems that happen if your sprinkler valve solenoid has broken, including: Constant water flow: The solenoid may stick open, allowing a trickle or full stream of water to move through the sprinkler, even when the system tries to shut it off.

The ESP-Me can control a pump start relay, to turn the pump on and off as needed. A Connect a wire from the pump start relay (PSR) to the. master valve terminal (MV) on the base module.

A Master Valve is a “normally closed” valve installed at the supply point of the main line that opens whenever a zone is operating. It is normally labeled "M," "MV," or "Pump." Please note, Master Valves should only be wired to the "M" and "C" terminals.

Sprinkler heads are rated at a specific GPM flow rate at a specific pressure. We recommend that you use 40 psi when designing your system.

Is 80 psi too high for an irrigation system? ›

Check your pressure at an outside hose bib

This will give you a baseline of the water pressure at your hose bib. Standard pressure should be between 40-80 pounds per square inch (psi). Pressures higher than 80 psi can possibly damage household appliances. Generally, the ideal pressure is 65 psi.

Is the water turned on, is the controller plugged in and programmed correctly, are there isolation valves that might be turned off? Verify valve operation by using the manual bleed. This might indicate a controller or wiring problem if the valve works properly when using the manual bleed.